787 ELT Fire Caused by Improper Battery Wiring

AINsafety » June 23, 2014
The ELT fire began in the top of fuselage near the vertical stabilizer.
June 23, 2014, 1:00 PM

The UK Air Accidents Investigation Branch (AAIB) investigation into the fire on board a Boeing 787 operated by Ethiopian Airlines at London Heathrow Airport on July 12, 2013, discovered improper wiring of the lithium metal battery that powered the aircraft’s Honeywell 406AFN fixed emergency locator transmitter (ELT). According to an AAIB special bulletin published last week, the investigation concluded that the battery had been incorrectly wired to the ELT during the manufacturing process.

To date, the AAIB said, 28 of the same model ELTs have been found with the same faulty wiring, prompting the agency to develop five safety recommendations for the FAA. The AAIB wants the U.S. regulator to develop enhanced certification requirements for the use of lithium metal batteries in aviation. It also advocates a new requirement that electrical performance and design-abuse certification tests for lithium metal batteries are conducted while these units are installed in parent equipment (such as an ELT) to view the battery’s thermal performance more safely.

Additional recommendations include testing to create the worst possible thermal-runaway cases before the units are installed anywhere and that the agency also require equipment manufacturers using lithium metal batteries to demonstrate they can mitigate all the hazardous effects of a thermal runaway or explosion.

The AAIB asked the FAA to investigate whether the technical standard order is the most effective means to certify batteries when their unknown characteristics can be duplicated only once they are installed inside another device.

Honeywell told the AAIB investigators that it is not aware of any previous in-service thermal events involving the ELT battery. Following a February 2013 incident in which a faulty ELT had been returned to the manufacturer with a discharged battery, Honeywell discovered wires trapped under the cover-plate, cuts in the gasket and insulation damage exposing the positive conductor. This prompted it to revise the assembly process for new ELTs but no inspections or modifications were recommended to operators of existing equipment or to the manufacturers of aircraft using the ELT.

Share this...

Comments

No Avatar
DWhite
on June 23, 2014 - 1:52pm

The article says that no inspection were reccomended for the wiring damage, but it fails to mention the multiple ADs issued for each fleet that carries this type of battery in a Honeywell ELT.

Immediately Adopted AD 2013-24-01 was issued in July 2013 for the 787 specifically with a 10 day threshold.

And AD 2013-18-09 was issued in September 2013 to address all Honeywell RESCU 406AF/AFN ELTs on all fleets.

No Avatar
Charles Alcock
on June 23, 2014 - 2:56pm

In fact, when the article says that no inspections were recommended for the battery wiring damage it was referring to the immediate aftermath of the problems uncovered by Honeywell in February 2013. In April 2013 corrective measures were introduced for new ELTs, but no guidance for repairing those in service was issued. 

You are right to say that ADs were subsequently issued but that was after the July 2013 fire.

Please Register

In order to leave comments you will now need to be a registered user. This change in policy is to protect our site from an increased number of spam comments. Additionally, in the near future you will be able to better manage your AIN subscriptions via this registration system. If you already have an account, click here to log in. Otherwise, click here to register.

 
X